Mag Controllers - Demag Controllers
Mag Demag Controllers
 
 

    Mag - Demag Controllers :

 
 
Mag Controllers - Demag Controllers

Mag Controllers - Demag Controllers : ( Category - Machine Tool, Machining operations, CNC machines, Electromagnets, Magnets, Magnetisers, Demagnetisers, etc.)

 
 
These are Magnetise and Demagnetise units for Electromagnetic Chuck.
The Electromagnetic chucks are used to HOLD the job in surface finishing machining  operations.
 
Input :  230 V ac Single Phase.
 
Output : 110 V DC at 2 amps. or 110 V DC at 6 amps.
 
Mag-Demag Controllers
   
Get Quote Normally MAG process continues for a long time ( minutes to hours ) and once the surface finishing is over, the job needs to be released from the chuck. Now the procedure of DEMAG  starts, which removes the residual magnetism in the chuck and the job gets released. The DEMAG process takes around 20 seconds.
   
The operations are without any Electromechanical relays in the output DC line. Both the MAG and DEMAG procedures are through Electronic Switches. Hence, the durability is high.
 
Power Supply Unit for Electromagnetic & Electro Permanent Magnetic Chucks
110V DC Power Supply is required for Electromagnetic Chucks. The Ampere rating starts normally from 2 amps upto 20 amps. These power supplies operate on 230V ac Single Phase  or  415 V 2 phase, ac 50 Hz. DC Voltage can be varied and set as per requirements. The magnetic force generated by a CHUCK varies as per the DC Voltage. Power of a CHUCK can be controlled. Power supply Unit is continuously connected to the Magnetic Chuck.
 
600 V DC Power Supply is required for Electro Permanent magnetic ( EPM ) Chucks. The 600 VDC is discharged into a winding coil of EPM chuck. EPM coil resistance varies from 1 Ohm to 6 Ohms.  The discharge current is in the range of 100Amp to 600 Amps. These power supplies operate on 230V ac Single Phase, ac 50 Hz. DC Voltage can be varied and set as per requirements. A  magnetic force generated by a CHUCK varies as per the DC Voltage. Power of a CHUCK can be controlled. User can activate the Magnetic Chuck and disconnect the Power Supply Unit.
 
Power Supply For Magnetic Lifters
It is similar to  a Power supply for EPM chuck.
 
Applications :
Milling Machines, Grinding Machines, Material Lifting, Raw Material Handling, Scrap Handling, Scrap Sorting, Finished goods handling, etc.
 
 
DC Voltage Power Supplies | Small Size Battery Chargers | Large Size Battery Chargers | Three Phase Controllers | Servo Voltage Stabilizers | Mag-Demag Controllers | DC Voltage Power | Battery Chargers | Three Phase Controllers For Power Control | Three Phase Power Controls | Cranker Rectifiers | Single Phase Servo Voltage Stabilizers | Three Phase Servo Voltage Stabilizers | Demag Controller For Electromagnetic Chucks | Capacitor Discharge Systems | Capacitor Pulse Discharge Systems | Switched Mode Power Supplies (SMPS) | Frequency Converters | Constant Current Source
We are Manufacturer Of Battery Chargers, Rectifiers, SMPS, Inverters, UPS, Servo Stabilizers and our setup is situated at Satara Road, Pune ( Maharashtra, India )
Home | Profile | Products | Contact | Feedback | Sitemap
Designed by : MID   Hosted by : GID   Promoted by : PBD